Mirro-Mastic®
Directions for Substrate and Mirror Preparation
1. Do not use on a painted surface, wall covering, or treated
wood.
2. For best adhesion, the mirror, substrate, and mastic
should be at room temperature (72°F, 22°C).
3. Make sure mirror and substrate are free of dust, clean,
and dry. On nonporous substrates, such as glass, tile, or
metal, sealing is not necessary. On porous substrates, such
as drywall or wood, use Mirro- Mastic® Bond (or
a primer or sealer, not paint) on the substrates
and allow it to dry. Painted surfaces should be sanded through
to the original surface and the substrate cleaned and sealed
where the mastic is to be applied. Wall coverings should
be removed and the substrate cleaned and sealed where the
mastic is to be applied.
4. Support mirror at the bottom. Mechanical fasteners must
be used for all mirror applications.
Directions for use of Mirro-Mastic®
1. Apply Mirro-Mastic® to the mirror or substrate in
a minimum of one (1) ping-pong ball size
mound for every square foot (.0929 square meter) of mirror
. Do not apply mastic too close to the edge to prevent "squeeze
out". Place the mounds so space will be left between
them when the mirror is installed.
2. Press mirror firmly in place making good contact between
the mirror, mastic, and substrate. Mastic should spread
to a pat approximately 4-1/2 inches (114 mm) in diameter.
The mastic needs air circulation to cure properly. Curing
time will depend on temperature, humidity, type of substrate,
and amount of air that can reach the mastic.
3. With minimum coverage, one gallon of
Mirro-Mastic® will install approximately 130 square
feet (12 square meters) of mirror, one 29 oz. cartridge
will install approximately 30 square feet (2.8 square meters)
of mirror, and one 11 oz. cartridge will install approximately
12 square feet (1.1 square meters) of mirror . When using
a gallon or five-gallon drum, the Electric Applicator and
Mastic Stik are available for ease of application.
4. Any clean-up can be done with mineral spirits.
5. For ceiling applications, technical questions, or a MSDS, please contact Palmer Products technical services at 800.431.6151 or by e-mail at palmer@mirro-mastic.com.
WARRANTY DISCLAIMER
Nothing herein shall be deemed to constitute a warranty,
either express or implied, by Palmer Products Corporation
with respect to Mirro-Mastic® or any other Palmer
product. Palmer hereby disclaims all warranties, including
without limitation, implied warranties of merchantability
and fitness for a particular purpose. This disclaimer
shall extend to all users of Palmer products and to any
third party. Any dispute or claim of whatsoever type arising
out of the use of any Palmer product shall be governed
by the laws of the Commonwealth of Kentucky. Palmer's
sole liability, if any, and any user's or third party
claimant's sole and exclusive remedy relating to any such
dispute or claim shall be replacement of the Palmer product
used.
Caution
Do not thin mastic. Keep away from
heat and open flame. Avoid prolonged contact with the
skin and breathing of the vapor. Use only with adequate
ventilation.
|
|
|
