Electric Applicator

Directions for Use:
1. It is important to remember to preheat the applicator for approximately 15 minutes. Dip into mastic and with a twist-of-the-wrist action, fill the applicator bowl.

2. Apply mastic to back of the mirror or the substrate. It is not necessary that the edge of the applicator bowl touch the surface, as the mastic will release itself. Apply a minimum of one (1) mound for every square foot (30.5cm) of mirror. Do not apply mastic too close to the edge, to prevent "squeeze out". Apply the mounds so space will be left between them when the mirror is installed.Press mirror firmly in place making good contact with the substrate.

3. There are approximately 130 pats of mastic per gallon when using the applicator.

4. It is recommended to always use a drop cloth.

Note: When using the applicator, occasionally wipe with a dry rag while warm. For future protection and longer life, clean the unit after each installation.When not in use, DO NOT leave applicator in the mastic. Use the metal cradle provided. If applicator is left in the mastic, the heating element will overheat and burn out.